The horizontal cylinder dryer has stable performance. In its structural design, the automatic tensioning device is specially equipped. Therefore, the chain plate runs smoothly and flips freely, solving the problems of chain-off, card chain and deviation. The sieve plate is made of heat-resistant steel and is meshed, and has high strength, is not easy to be deformed, and has good gas permeability.
At the same time, during the operation of the horizontal cylinder dryer, the operating speed can be adjusted according to the operation requirements to control the drying time. The digital temperature of each section of the kiln shows that it is easy to grasp and control the temperature in the kiln. Moreover, there are maintenance passages on both sides of the kiln body to facilitate the maintenance of the equipment. In addition, there are fire protection devices, kiln head, kiln, kiln tail, three thermocouples, smoke door at the air inlet of the flue, once the machine fails, immediately put down the gate to block the heat source to prevent fire.
The horizontal cylinder dryer adopts negative pressure to induce air, so the dust generated is small, and the drying is uniform, and the use is simple and convenient. Under normal circumstances, the outlet air temperature of the negative pressure draft kiln is ≤100 °C, the dust content is small, the life of the induced draft fan is long, and the running cost is low.http://www.csspraydryer.com/